How To Draw A Diamondback Rattlesnake

Page 3 of 4

Step 10: Draw the rattlesnake'south lower jaw using the arc at the bottom as a guide. Follow the basic path of the guide merely make the shape curvier as y'all darken the lines.

Footstep 11: Add the rattlesnake's gums and teeth above the top line using a serial of curved lines.

Footstep 12: Utilise the initial curved line as a guide to draw the top part of the rattlesnake'southward torso. Follow the bones path of the guides equally you darken the lines and make the shape thicker. The peak of the body should curve away from the snake'due south caput and human action like a spring ready to strike. Sketch lightly at commencement, then darken the lines when you lot get the shape right.

Footstep 13: Proceed adding the middle section of the rattlesnake'south body by using the initial line as a guide. Option up where you left off and extend the lines that make upwardly the body farther down as you follow the path of the guide. Brand the shape of the serpent's body thicker the closer you get to the eye at the bottom. Sketch the shape lightly at first and only darken the lines when you get the structure correct.

Stride 14: Finish the rattlesnake's body by using the initial guide to draw the bottom part of the rattlesnake. The lower part of the body curves dorsum behind the middle department, so brand sure these lines don't overlap. Go out a small-scale section open on the line at the top shut to the tip of the tail because this is where the rattle will go.